Skip to content
PrivatePilot.NEWSPrivatePilot.NEWS

News for pilots, student pilots and everyone interested in aviation

News

FAA requires door inspections on Diamond DA40

A new US airworthiness directive requires inspections and an updated flight manual. European owners must also check compliance with the earlier Canadian directive.

By PrivatePilot.NEWS · published 15 November 2026 · 07:00 UTC

AI-illustrasjon
Photo: AI-illustrasjon / PrivatePilot.NEWS

The FAA has adopted airworthiness directive AD 2026-22-06 for all serial numbers of the Diamond DA 40, DA 40 F and DA 40 NG. The directive was published on 2 November and takes effect on 7 December 2026.

The directive follows several cases in which the passenger door detached in flight. Transport Canada states that some incidents could be linked to improper latching and subsequent attempts to latch the door in flight. The cause of the other incidents remained unresolved when the Canadian directive was issued. A detached door can damage the aircraft structure, lead to loss of control and injure people on the ground.

Inspections, placards and an updated flight manual

The measures are based on material from Diamond. Transport Canada's directive refers to a temporary revision of the flight manual and service bulletin MSB 40-103/MSB F4-042/MSB D4-114/MSB 40NG-084, revision 2 dated 5 June 2025, with the associated work instruction. The material covers revised procedures and limitations, cabin placards and inspections of the door's latching and safety hook mechanisms. Canada describes the measures as interim and leaves open the possibility of further directives.

For pilots, this means that both the aircraft's technical status and the correct edition of the flight manual are relevant. For owners, flying clubs and flight schools, a practical follow-up is to establish with the person responsible for maintenance which measures have already been carried out and how they are documented. Instructors and others using the same aircraft should know the approved procedures applicable to that particular aircraft.

US compliance periods begin on 7 December

The FAA requires the flight manual update and the initial inspection and placard installation within 100 hours TIS or 100 days after the effective date, whichever occurs first. The scope of the inspection depends on whether the aircraft has less than 100 or at least 100 hours total TIS at that time.

Some findings trigger requirements for repetitive inspections or replacement. Certain discrepancies must be corrected before further flight. Details are set out in paragraph (i) of the directive.

Owners in Europe must also be aware of the earlier directive

Transport Canada's CF-2025-30 took effect as early as 7 July 2025. It covers the DA40, DA40 F, DA40 NG and DA40 D, all serial numbers.

EASA explains that airworthiness directives issued by states of design outside the EASA system generally become automatically applicable to affected EASA-approved or validated designs from the directive's effective date, unless EASA decides otherwise. The Canadian directive is also listed in EASA's publication register.

For affected aircraft under EASA rules, CF-2025-30 is therefore a key document to check for compliance. The FAA's date of 7 December 2026 provides no new deadline for requirements already imposed by the Canadian directive. The two directives must be assessed separately under the rules applicable to the aircraft.

The practical task is to identify the correct model and serial number, check the relevant AD compliance status and documented work, and ensure that the flight manual and placards meet the requirements. For questions about how to carry out the work or the remaining compliance periods, the person responsible for maintenance should consult the directive itself and the specified revisions of the supporting work documents.

Sources